Open a canvas 800x264.
Selections/ load selections from disk/ locate the scissor1. Add a
raster layer and flood fill with silver gradient, 134 angle.
Load the scissor2. Add a raster layer and flood fill with silver
gradient, 180 angle.
Selection tool/ Freehand. Make a selection as shown on the screen
shot.
Adjust>Add/Remove Noise>Add noise. Uniform/ Noise 30%/ Monochrome
checked.
Adjust/ Brightness and Contrast. Brightness -50/ Contrast 0.
Load the scissor-handle1. Add a raster layer and flood fill with any
color you want. Effect/ 3D effect/ Inner Bevel. Settings below.
(Note if you have a SuperBldepro, use the plain.9q9 preset.)
Load the scissor-handle2. Add a raster layer and flood fill with the
same color. Apply inner bevel.
Load the ellipse-selection. Add a raster layer and flood fill with
silver gradient. Apply inner bevel. Settings below.
Deselect. Effects>3D Effect>Drop shadow. Setting: Vertical 0>Horizonal
-2>Opacity 100>Blur 2>Color #000000.
Pen tool/ size 2/ Point to Point/ color #000000. Draw a diagonal
line across the ellipse. Convert to raster layer. Add drop shadow,
change the Vertical line to 1 and color to #ffffff.
Merge all the layers visible and save your image.
End of Tutorial
|
