|
PSP Wicker Basket Tutorial Page 2 |
||||
| Deformation Tool. Hold the shift key down and drag the right corner slightly in. |
|
|||
|
|
Still on deformation tool. Pull the top part slightly down. | |||
|
Preset shape/ ellipse/ size 15. Foreground wicker pattern/ set the
angle to 45 and change the scale to 50.
|
|
|||
|
Place an ellipse on top of the image. Convert to raster layer. Apply Inner bevel Change the settings to Width 2/ smoothness 50/ depth 5. DESELECT.
|
||||
|
Pen tool/ Point to Point. Draw a point to point
line from one end to the other end above the image.
|
||||
|
|
Add a node on the center of the line and drag the node up. Edit the node to Symmetric. Slightly pull the node arrow to the left. Adjust both ends. Your image should look similar to the screen shot. | |||
| Convert the layer to raster layer. Make the layer selected and apply drop shadow. Use the same settings. OK DESELECT. Merge all the layers visible. Save your image. | ||||
|
Move the image up a little. Preset shape/ ellipse. Foreground/ fill
to wicker pattern/ 45 degrees angle. Draw an ellipse below the image, this is going to be the base.wss18. Convert to raster layer. Make it selected and apply inner bevel |
 |
|||
|
|
Preset shape/ Ellipse/ size 10. Foreground to wood1/ no fill. Draw
an ellipse just below the base.
|
|||
| Burn Brush/ size 28/ hardness 8/ step 1/ density 36/ thickness 100/ rotation 0/ opacity 22. Run the burn brush below the basket and on the the round base. If you like what you see, then save your image as psp or tube file. | ||||
|
End of Tutorial |
||||
